Results 1 to 10 of 39
Thread: Auto leveling
Threaded View
-
03-04-2014, 04:04 PM #1
Auto leveling
Hey guys,
Just wanted to make a small blog of this topic,
I am going to order a servo and new micro switch, And i should try in the near future depending on the shop delivering it on time to get my printer up with auto bed leveling,
I first didnt know if i should do this as i have a fan duct that uses all that space wich i would need to remove to get this auto bed leveling in place,
But i guess it will be worth it, hopefuly,
Might also buy a new hotend after this wich probably would be a E3D hotend as its been proven to do reasonable prints,
Tryed other hotends but they just didnt fit the printer, and the E3D will.
Anyhow,
Best regards,
DrLuigi
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help