Results 1 to 10 of 15
Thread: Reprap Electronics
Threaded View
-
03-03-2014, 04:23 AM #11
You will have to flash your board. It is quite simple, once you've done it, but it can be a bit daunting at first go.
Look at this video: http://www.youtube.com/watch?v=sOojWpuci_o
Although it is for the Makerfarm Prusa i3, the basics are the same for any RAMPS 1.4 Arduino board. You could download the MakerFarm RAMPS files to give you a starting point, but you will have to do some trial and error work to adapt it to your printer.
You are lucky. If you hit a brick wall, come back here with your problem and someone will be able to put you right.
Old Man Emu
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help