Results 1 to 2 of 2
Thread: Creator Pro under extruding
Threaded View
-
02-11-2016, 11:56 PM #1
- Join Date
- Jan 2016
- Posts
- 8
Creator Pro under extruding
My Flashforge Creator Pro has suddenly started under extruding. I've taken out the stepper motor and cleaned it, and the problem persists. When I had the motor off, I had a look at the nozzle and it may have been clogged. I'm not 100% sure though, this is the first time I've run into this problem on my printer.
Any advice on what to do, or what I should look at in this case? Currently printing using PLA at 230 degrees, if that makes a difference.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion