Hey there fellow backers, I decided I needed a place to post my prints and How to videos so they didn't end up all over the place. Let's start with build videos:


Unboxing the V1 kit:


Building the V1 printer:


Building the standard drip system (highly recommended):


So far, I am very pleased with how the peachy performs. It clearly has the capability to print highly detailed objects that would be nearly impossible for an FDM printer. Here is my first batch of prints from the peachy:












I have also done a few print not from the print library, but I have just begun to play with the settings, so these prints are going to be much rougher for a while until I get Gcode figured out:

1 cm cube (it is 1 cm high, but only 7 mm wide)


d20 (lopsided, numbers didn't come through strongly, but perfectly full and no holes or problems otherwise, too big attempt to the right)


I will be updating this thread as I print and film more peachy stuff, and I hope I can help with build questions for people who used my videos to build their peachy.