i cant figure out what is causeing the prints to drift. at 1st i thought it was to much slack in belt but found i have it at tension i need it at, i marked the belt on the back side with a white crayon so i can see if stepper was skiping and it dosent that i can see (mark is in same spot after 3 atempted prints when i home), and i have tryed sevral aheasion techneques to make sure that wasent issue (nothing on bed, glue stick and painters tape with glue) no matter the method i use the drifting is always the same, im at a lose now and only thing left i can think the issue might be is stepper itself is bad. iv only owned this printer for a little over a week now so im realy hoping it isint that but if i need to replace it ill have to. image of the 3 prints side by side attached.
12313925_968500429895228_375578798443966829_n.jpg