Results 1 to 4 of 4
Thread: Ridged prints from Prusa I3
Threaded View
-
10-06-2015, 06:02 PM #1
- Join Date
- Oct 2015
- Posts
- 2
Ridged prints from Prusa I3
Howdy all - I'm hoping you can help me out. I finally have my Prusa I3 printing, but the second and subsequent layers seem to have ridges and smear into the lower printed levels. I have attached a few prints to show what is happening. I'm not sure what is causing the issue - am I not raising the nozzle far enough after each print? If so, I'm not sure what I need to do to make the modifications.
I am using Repetier-Host and Slic3r to print and slice, respectively. I am printing using 1.75mm ABS. My print board is RAMBo 1.3.
Hopefully the guru's of wisdom can help point me in the right direction. Thanks all!
20151006_173528[1].jpg20151006_173541[1].jpg
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion