Results 1 to 10 of 22
Thread: Hexagon vs E3D V6
Threaded View
-
09-08-2015, 04:35 PM #8
I have a roll of 1.75mm ABS from Makerfarm in Blue that I have to hand feed, otherwise it stops feeding, which I feel is bumps. My Hatchbox does not have this issue, and if I hand feed the makerfarm filament it works fine. Something about pulling off the spool, and I think getting to a slight bump. there is never a jam, it just stops feeding.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion