Results 1 to 8 of 8
Threaded View
-
09-04-2015, 07:19 AM #1
- Join Date
- Sep 2015
- Posts
- 4
3d printing firmware extruder help
Hello
I am developing my own 3d printing software and have trouble with the extruder.
I have read that the gcode g1 command moves to the given position.
but there is also a E paramenter which pulls out the given amount of fillament from begin to end.
But is this function needed?
If yes:why?
Or Can i just make it that the speed of it is set To match the speed of the x and y and z axis.
Or will my 3d prints than be incorrectly printed?
Can anyone help my?
Thanks
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion