Results 1 to 3 of 3
Thread: I bought some new nozzles, but
Threaded View
-
08-29-2015, 12:54 PM #1
- Join Date
- Aug 2015
- Posts
- 1
I bought some new nozzles, but
I bought some new nozzles that r not identical to the original e3d style.
The stem is about 4mm shorter than the orig.
I like them because they do not have a flat spot on the face that I think is causing issues.
I like they way it works, ONLY problem is sealing the PLA in.
Because of the short shaft it will not butt against the barrel to seal.
I have not disassembled to see if I can screw the barrel in another 4-5mm to get the proper seal but if I can I may not have any heat break left.
Is there another method I can use to seal it or do I have to abandon these?
any other ideas?
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)