Results 1 to 7 of 7
Thread: Corner curling up
Threaded View
-
08-04-2015, 02:58 PM #1
- Join Date
- Feb 2015
- Posts
- 371
Corner curling up
I am having issues with the corner of one of prints curling up. It is symmetrical design and the opposite corner is fine. After watching the print it appears that this is where the layer change is happening. Is there a way to clean this up? A wipe move? What is causing this? Retraction setting too high, not enough?
Attached are some pics.corner curl.jpgcorner curl2.jpg
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion