Results 1 to 4 of 4
Thread: custom start codes
Threaded View
-
06-10-2015, 03:36 PM #1
- Join Date
- Feb 2015
- Posts
- 371
custom start codes
What has been bothering me is the ooze that I am getting while the printer walks through the ABL program. I don't like how the printer brings the nozzle up to temp and the bed, then does the ABL procedure. This does this in Cura and Slic3r. I'd like the program to do the following...
1. heat the bed,
2. do the ABL,
3. move to a preset location,
4. Heat the hot end,
5. extrude some filament,
6. Run the code,
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion