Results 1 to 3 of 3
Thread: Extruder No longer heats up
Threaded View
-
04-12-2015, 07:35 PM #1
- Join Date
- Jan 2015
- Posts
- 445
Extruder No longer heats up
Good evening... So i started a print, went to bed. Woke up it was half done. but the layers split and it quit midway through. Just thinking it failed, didnt think anything of it.
Tonight i go to print something and it wont heat up the extruder. I set it to go, and nothing.
THe bed heats up just fine, but extruder. Nada.
Its a hex from makerfarm prusa kit.
The thermistor is still in the head. all the wiring looks good. Is there anything easy to check? a fuse? or something?
the HE1 light comes on on the rumba board as well.
THanksLast edited by dunginhawk; 04-12-2015 at 07:41 PM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion