Results 1 to 6 of 6
Thread: Building a printer from a kit
Threaded View
-
03-31-2015, 09:54 PM #1
- Join Date
- Feb 2014
- Location
- Tyler, TX
- Posts
- 18
Building a printer from a kit
I am collecting parts for a DIY 3D printer and am ready to pick a frame. I already have 5 Nema 17 stepper motors, an arduino mega 2650, a ramps 1.4, and a E3D V6. I need a frame and extruder for somewhere around 7" x 7" x 7" build volume or greater.
I am looking at the Mendelmax 1.5 RepRap kit but that is just the plastics. If the hardware isn't too difficult to find then that could be a good option.
Any other's I should be looking at?
Thanks!
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion