Results 1 to 3 of 3
Threaded View
-
03-30-2015, 06:21 AM #1
- Join Date
- Mar 2015
- Posts
- 18
Thoughts on improving this test model
http://i.imgur.com/vcZ963W.jpg
Printed on a Makerbot Z18 using the following settings:
- 0.15mm
- 5th Gen High Base
- As default offset
- 20%infill
- 200 °
- Roof layer count 4
- High
- 90mm/s
- Shells 2
- Outlines 15
Thoughts
- Increasing shells increased integrity at cost of cleanness
- Increasing temperature makes raft bond even at 207
- Decreasing speed increases cleanness at cost of time
- ?Increasing roof thickness seems to have no impact on depth of roof but slows down and lowers print quality.
- 0.15mm easily achievable vs 0.1mm
Have tested all default profiles and this has been the best so far.
What do you recommend I change to improve it?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion