Results 1 to 10 of 11
Thread: Level Bed Graph
Threaded View
-
03-25-2015, 10:41 PM #1
- Join Date
- Dec 2014
- Location
- Canada
- Posts
- 498
Level Bed Graph
I took apart my Y axis and bed to try and improve how level the bed it by default
I measured all spacers, and washers to try and mix and match them so that its as close to even as i could get.
not using any springs.. all spacers all around. so the bed sits solid.
Finally got it reassembled.
Did a before and after measurement using a Dial caliper to measure bed distance from X carriage in 20 spots
I compared this to after I did a ABL Routine
These below charts are exagerated to make it clear
White is Flat
Red is default bed with no auto levelling
Green is after Auto Levelling
On the red the deepest valley was -.52mm and the highest hill was .92mm
the middle of the bed was 0 on all three. also the very left side was not measured thats why it all comes together
Not sure what is causing it to raise up in the back right corner.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion