Results 1 to 3 of 3
Thread: Used G-Code Commands?
Threaded View
-
03-18-2015, 09:53 PM #1
- Join Date
- Mar 2015
- Posts
- 59
Used G-Code Commands?
I have looked at the G-Code references, etc. Currently my control software attempts to correctly handle all of the commands that could possibly apply to 3D-Printing, though it would be made simpler if I could ignore a few more of the G-Code commands.
So is there a list of the G-Code commands actually produced by the slicers in common use?
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion