Results 1 to 10 of 41
Thread: Lead screw upgrade
Threaded View
-
02-08-2015, 03:41 PM #13Thoughts on this lead screw
I think it was either Prusa himself or Triffed Hunter that argues that on a threaded rod Z you ideally have a layer height that is an even number of full steps (not a microstep). I didn't bring up the Prusa calculator, but it seems if you follow that rule you'd end up with some odd layer heights.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion