Results 1 to 6 of 6
Threaded View
-
01-31-2015, 10:41 AM #1
Need a new car? Extend those rails on your Makerfarm and get going...
I knew it was coming sooner or later. 3d printed cars... So, upgrade your printers rails and get started, it will be spring soon. Plus, at 30mm/sec on my Makerfarm, it might take a few thousand hours to complete. I hope it sticks to the bed. And, if it warps on the corners will that make my front end out of alignment?
https://www.youtube.com/watch?v=aMQJkkchTi4
(I searched the forum to see if this has been mentioned before but our search engine found nothing so I hope this is not redundant.)Bambu P1S/AMS
NVision4D http://nvision4d.com
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help