Results 1 to 5 of 5
Threaded View
-
01-13-2015, 08:10 PM #1
- Join Date
- Jan 2015
- Posts
- 445
My second 3d printer... Quality a must!!!
Good evening guys and gals... So I currently have a rostock max v2, which i love... its been hard to tune, but its pretty solid now.
So I find out soon whether I am going to be awarded a relatively large job (considering the usual small jobs you run in to on 3dhubs etc).
It will pay enough to buy a decent 2nd printer. Not great, but decent.
So , if I was dead set on quality prints, speed is not the object where would i go?
I would like it to be a a direct feed system (vs the rostock bowden tube etc) because i want to print flexible filaments, copper etc better (i can now, but its tough).
I am looking in the $1000 - $1500 range... and it must have a build area of at least 8" x 5" by only a couple tall.
WOuld love to start a discussion, I humbly request your help.
thank you
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help