Results 1 to 10 of 232
Threaded View
-
12-17-2014, 11:22 PM #11
- Join Date
- Jul 2014
- Location
- Eastern Colorado
- Posts
- 536
I haven't really had much use for the LCD since I started using the OctoPi. I haven't even used the SD card. While the print is running from the OctoPi, the only info the LCD gives is temperature and location. I do use the LCD knob, though, to resume a print if my filament runs out and triggers a pause switch, though I could do that with any momentary switch, I think. Now you've got me thinking about removing my LCD. As for a display being required for the Raspberry Pi, not necessarily. I access my RasPi over wifi from my Ubuntu laptop. I open a terminal and SSH into the RasPi via its router address. Then I can do the setup from my laptop (only because I have zero hdmi-capable displays in my home, and I didn't want to buy any).
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help