Results 1 to 3 of 3
Thread: Wrong hot end?
Threaded View
-
12-01-2014, 11:53 PM #1
Wrong hot end?
I have having a bad time with my hot end jamming. It is not a leveling problem. I have removed the bed and and ran a print. It still jams. What is happening is the filament is coiling up in the hot end. I did not think much about it at the time. But my hot end looks different from the assembly instructions. The opening is larger and the fitting screws right into it.
Even though the printer came with 1.75mm filament. I was wondering if I should be using 3mm?Last edited by Starlord; 12-02-2014 at 12:02 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion