Results 1 to 4 of 4
Threaded View
-
11-26-2014, 01:44 PM #1
- Join Date
- Nov 2014
- Posts
- 3
Should the extruder body be perpendicular to the Z axis ?
Hi.
My Prusa i3 has the extruder body about 5 degrees inwards with regards to Z axis. (that is, the nozzle tip is looking inwards). Is not parallel.
Is this a factor should I worry about? Which would be the effect on prints ?
luiss.Last edited by luiss; 11-26-2014 at 01:59 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion