Results 1 to 10 of 172
Threaded View
-
11-06-2014, 10:00 AM #11
Oh! I started with my origin in the front left. That is where most people have it. But because the only place I could put a Z-Probe was on the front left, it was probing in negative space. What I did was move my origin to the back right. You do this by just changing this:
#define INVERT_X_DIR true //false // for prusa i3 set to false, x endstop should be on the left
#define INVERT_Y_DIR true //false // for prusa i3 set to false, y endstop should be in the back and opposite the y-motor
#define INVERT_Z_DIR false // for prusa i3 set to false, z endstop should be at the bottom
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion