Results 1 to 4 of 4
Threaded View
-
09-25-2014, 11:59 PM #1
Newbie here with basic questions!
Hi everyone! I'm very excited that I have my printer up and running. But now I have a few basic questions.
1.) What temperature do you guys recommend for the hot end and (basalt)heated bed? I plan on using PLA almost exclusively, from this source (http://m.ebay.com/itm?itemId=281205964207)
2.) What speed do you recommend for the feed rate? I prefer quality over speed.
3.) Do you recommend using a fan for PLA, and if so what speed?
4.) Do you have any special tricks or a routine for preparing the build surface? Taping, cleaning, spraying, etc
5.) Any thing else you can think of!
EDIT:
My printer is a QU-BD Two-Up, if that helps!
Thanks for the help!Last edited by Apollo; 09-26-2014 at 11:38 AM. Reason: Forgot to include the type of printer I have
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help