Hellooo. So, I just got my new e3dv6 hotend and last night I was about to print but while it was heating up I noticed a burning smell and some smoke coming from the hotend so I switched it off and turned it back on and I got an error saying the temp was at 309c....

So, I put my room fan on it and let it cool down, after it cooled I took it off and saw that one of the legs had broke off the thermistor, I have my old one that I got with my Hexagon hotend but it is a bit bigger than the one that came with the e3d but it fits nicely in the hole that a screw goes in to to hold the original thermistor in place, will this be ok?

Pic:


Cheers.