Results 1 to 8 of 8
Threaded View
-
08-01-2014, 05:17 PM #1
Changing infill pattern via proftweak
Infill pattern is honeycomb by default.
Sure it's strong, but slow to print and hard on the printer if printed at speed
Are there any other patterns available ?
A simple rectilinear one would be fastest and least wear on the printer.
Okay not as strong - but honestly I don't need every model to be super strong.
For a lot of stuff I'll want to print speed not is what I want not neccessarily the ability to jump up and down on it with out it breaking.
I figure a 10% rectilinear infill would cut print time down by about 50% from the honeycomb infill. Plus it would also extend the printer life :-)
So are there any other patterns available and if so - how do i change them ?
***
Ah ha !
I feel a small box test print coming on :-)Last edited by curious aardvark; 08-01-2014 at 05:37 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion