Results 1 to 6 of 6
Thread: Newbie with FlashForge Creator
Threaded View
-
07-11-2014, 06:33 AM #1
- Join Date
- Jul 2014
- Posts
- 2
Newbie with FlashForge Creator
I am a newbie to 3D printing, I jumped into it with the Creator 3D. I think I did everything correctly, but I am not sure how to correct the error in cubes. Any help would be greatly appreciated. A globe turned on perfectly round and looked good, but cubes tend to start smaller on the bottom and have a slight taper outward towards the top. I have attached a link to the pic.
2014-07-11 07.20.32.jpg
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion