When I try to auto home, X and Y seem to move fine but when it goes to home Z, it either zips to the middle of the bed or it stays where it is and just moves up about 5 mm. The printer worked perfectly fine last night. This issue only started this morning when I turned it on. I've flashed the firmware and installed the latest version (Ender-3 V2-HW-V4.2.2-SW-V1.0.5T-SpritExt-20220714.bin) but the issue stills persists. Any help would be appreciated. I've uploaded a short video to youtube so you can see whats going on https://www.youtube.com/watch?v=N3KUP-E5Wnk