Results 1 to 10 of 14
Thread: Prints with holes
Threaded View
-
06-08-2014, 04:36 AM #1
Prints with holes
Hello everybody,
With this topic i would like to ask you guys if you would know how i could resolve some problem i've got with my makerfarm,
When ever i make a print with a hole inside its always to small,
The outside is always correct on 0.1mm tolerance, But the inside is most of time not a circle, It has a tolerance of 0.8mm most of the time,
One side is sometimes when measuring perfect on the measurement i wanted, But then when you go further in that circle it goes down.
Thanks if you would know the solution since i don't know what to do anymore with em :P
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help