Results 1 to 1 of 1
Threaded View
-
07-28-2022, 11:44 AM #1
- Join Date
- Aug 2021
- Location
- Aubrey TX
- Posts
- 9
Aquila - VoxelMaker & Cura - Rough 2nd 3rd Layers
I tried posting in Tips, Tricks and Help but got no help. Hopefully the General discussion Board will do better ... ... Aquila, now equipted with an Ender 3 Direct Drive Extruder/Hot End, using VoxelMaker and Cura slicers .... ... Initial Layer is GREAT, very smooth, sticks well ... 2nd Layer shows some rough spots and sometimes a 'wave like pattern' ... 3rd layer gets rougher .... after infill completes, roughness continues. 2nd & 3rd Layer appear to 'bubble up' around the edges of finished project (see attached picture) ... I am stuck ... would like suggestions on where to look for issues in setup and what to fiddle with to make work ... thank you
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion