Results 1 to 10 of 13
Thread: Print perforation
Threaded View
-
06-15-2022, 02:25 AM #11
- Join Date
- Jun 2022
- Posts
- 7
This was actually my first attempt to tackle the challenge, too, but with holes smaller than a millimeter the Software couldn't handle it at some point. Furthermore, the 3D Printer has to be able to print it. That's why I switched to doing it via the Slicer. It kind of works with the lines infill and no walls, but it's just not good enough.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion