Results 1 to 6 of 6
Thread: Need some help
Threaded View
-
05-20-2014, 08:04 PM #1
- Join Date
- May 2014
- Posts
- 11
Need some help
Finishing up on my I3v and I tried to wire in the power supply using an antec vp450 and nothing happened when I turned it on? Could it be possible that I crossed some wires after I snipped the tips off? This could be either yellows or blacks. I don't think I did but it's the only thing I can think of. If this is the case how do I tell which goes to which? Thanks
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion