Results 1 to 6 of 6
Thread: X-Idler Top Plate *.stl file
Threaded View
-
04-22-2014, 07:14 AM #1
X-Idler Top Plate *.stl file
This is the top plate of the Prusa i3 X-Idler:
X idler.jpg
which is located here: Location of plate on printer.JPG
The long screw goes through this plate and activates the Z-axis endstop switch can come break out from the plate because it is too close to the edge of the plate. I have created an *.stl file of this plate and produced this:
The printed plate.jpg
The large hole is for the threaded rod to go through and the smaller, 3mm is for the long screw.
Here is the *.stl file:
Z-axis endstop block.stl
Old Man Emu
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion