Results 1 to 10 of 474
Threaded View
-
01-30-2018, 09:04 PM #11
- Join Date
- Jul 2017
- Posts
- 193
One at a time prints ok, but a pair causes a slant, weird indeed. How does it look in the slicer, layer view prior to printing? If you pass me the STL and or the gcode, I will give it a shot on my printer. ( unless its too big ).
So I took my printer apart again to get to the board to get to the bottom of my fan issue. I was able to capture a good clear photo that shows a burn mark and rework on the MOSFET driver for the fan. Hopefully, HE3D will now send a replacement board as I cannot repair it ( my skills are not up to it ).. Attached snippet of the photo.
HE3D-Bad-Component.JPG
Finishing the install of the PrintBite. Got acetone and will be heat soaking tonight.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery