Results 1 to 10 of 15
Threaded View
-
10-15-2017, 11:26 AM #6
Hello;
You should check voltages and make sure that the 12 Volt Supply is supplying 12volts.
Then we need to make sure that the 12 volts is correctly connected to the controller card.
Do you have a multimeter?
"Never mind I see you do in the photo"
I Have two Hictop 3D Printers, and We can Get you up and running.Last edited by Roberts_Clif; 10-15-2017 at 11:50 AM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion