Results 1 to 8 of 8
Threaded View
-
09-03-2017, 12:02 PM #1
- Join Date
- Aug 2017
- Posts
- 95
Fastening glass to build table - Qidi XOne
i have been using binder clips and it works OK... but I find that when I remove it and then reclip it or the other glass in I most often need to readjust the level or I get bad first layers and a ball of plastic. So that sort of negates the whole idea of using clips in the first place. So I was thinking of a more permanent solution.
On my Qidi X One there is no room to install those plastic corner clips I see that are often used for other printers. So I was wondering if there is some ultra thin high temp double sided tape or some such that would work. Other ideas?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help