Results 1 to 10 of 474
Threaded View
-
07-30-2017, 12:33 PM #11
Just fitted the cable snake - yep that works :-)
I fixed the cable in at the bottom with a small black cable tie. Was going to do the same at the top - but doesn't seem to be necessary :-)
I'll upload stl and scad to thingiverse :-)
Looks great in operation - moves back and forth. As i tunrs out I could actually have got away with a much steeper angle on the connector tab. Which would have printed cleaner.
Who cares, it works :-)
I'll change it for the stl upload.
Changed it from 30 degrees to 50 - yep that'll print a lot easier :-)Last edited by curious aardvark; 07-30-2017 at 12:53 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion