Results 1 to 10 of 18
Thread: One side of my prints are awful
Threaded View
-
06-27-2017, 05:52 AM #9
You did check the gears on the stepper motors were all tight.
I have to admit the auto levelling, made absolutely no sense to me and as I have a perfectly flat bed. Just levelled with my adjuster bolts for the heated bed.
But given that the first few layers are going down fairly clean.
I don't think that's the issue, still leaning towards some kind of mechanical issue.
Although if the auto levelling tells the printer the bed isn't level and to adjust for a non-level bed then that would probably be carried through the whole print.
Can anyone actually explain how the whole g29 measurements are used. I tried to follow the he3d video, but it didn't do what his did on the video and the maths made absolutely no sense whatsoever.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help