Results 1 to 10 of 16
Threaded View
-
01-03-2017, 11:40 PM #11
- Join Date
- Aug 2015
- Posts
- 15
The motherboard has a single PCIe slot, which I am using for the USB 3.0 card. The built-in USB 3.0 ports actually give the same response as the card: the Verifier tool is able to recognize the port as being supported but having unknown bandwidth, and then it is able to actually receive 3d video data at 30 FPS. Meanwhile, 3D Scan gives a gray screen for both.
If my motherboard just can't handle it, that's too bad, but the Kinect isn't even turning on when 3D Scan runs. Maybe 3D Scan gets to the stage of unknown bandwidth and just gives up.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion