Results 1 to 8 of 8
Threaded View
-
12-29-2016, 05:22 PM #1
- Join Date
- Dec 2016
- Location
- Idaho
- Posts
- 5
Hictop prusa i3 Z height issue after Firmware Flash due to Auto Level kit install
Hellllooooooo Printer Geeks
!
I just installed the Auto Level Kit on my printer. Afterwards I used Cura to flash my 3DP08 to 3DP12 via the hex file provided to me by Hictop.
My printer is http://www.hic3dprinter.com/products...&id=25&cid=001
Now my Z axis height will no longer go all the way up and travels VERY slow. In the menu it shows it went up 200 but in actuality it only goes up about 3.5 inches max
.
This is ruining prints and I need this fixed asap as I am now having a backlog of prints.
Can someone please help me?
PS, I'm a moron when it comes to manual programming of any kind....hence using Cura to flash the hex update file and not using Arduino in any way like I see on other forums.
Cheers!
RIP Carrie FisherLast edited by DarthViking3DPrinting; 12-30-2016 at 11:28 AM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help