Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 52

Thread: Clogged nozzle

Hybrid View

  1. 01-13-2015, 09:08 PM #1
    danrodz
    danrodz is offline
    Student
    Join Date
    Nov 2014
    Posts
    34
    Quote Originally Posted by gmay3 View Post
    Have you tried enabling the skirt option in your slicing software to print a skirt around your print to purge the nozzle?
    Yes, I actually have it set to do 3 as everything typically starts to flow smoothly after the 1st go around or so.
    Reply With Quote Reply With Quote
  2. 01-14-2015, 08:31 AM #2
    gmay3
    gmay3 is offline
    Engineer-in-Training gmay3's Avatar
    Join Date
    Mar 2014
    Location
    USA
    Posts
    388
    Add gmay3 on Thingiverse
    Quote Originally Posted by danrodz View Post
    Yes, I actually have it set to do 3 as everything typically starts to flow smoothly after the 1st go around or so.
    Ah ok, just checking. I wasn't sure if this could maybe replace cleaning out the nozzle manually with the wire.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules