Results 1 to 10 of 15
Thread: Print bed leveling problem ?
Threaded View
-
12-02-2014, 04:24 PM #14
- Join Date
- Jul 2014
- Location
- EU
- Posts
- 26
I assume you got one of the Creators.
Beds on these tend to distort with temperature, so if you preheat to 120 it's good to recalibrate.
I would also advise to remove one of the springs from the print bed to get a 3 point leveling (left-back is my fav), with 4 points you'll always get tension on the bed. If the bed is warped by default, you can try to use the 4 screws to compensate the warping, though.
Dreamer comes with glass bed and 3 point bed calib by default.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials