Slow getting to 110C bed target on 10" i3v

[Drone]

For my i3V 10 where I put the clip for my glass makes a major difference. When I moved my clips to the front and back of the printbed it took forever to reach 110c, and when I put them back on the sides it only takes a few minutes to heat to temp. YMMV, but it made a big difference for me. Even where I put the clips on the sides makes a difference.

[JimG]

For my i3V 10 where I put the clip for my glass makes a major difference. When I moved my clips to the front and back of the printbed it took forever to reach 110c, and when I put them back on the sides it only takes a few minutes to heat to temp. YMMV, but it made a big difference for me. Even where I put the clips on the sides makes a difference.

Interesting. I recently moved 1 of the 4 clips a little further from the middle of the board. Would not have thought that would affect heating of the bed!

Jim