Results 1 to 10 of 14
Hybrid View
-
11-16-2014, 12:33 PM #1
Oh, I could be wrong about how the commands are issued. I assumed people were doing the extra commands involved manually through host software. I don't have ABL on my printer - I'm just familiar with the designs of the RAMPS and MEGA2560 boards. What you could do is wire in a small 5V power supply (like an unused wall adapter) as a 5V source for the servo. I'd have to look into how that is done. FYI - details on the analysis of the MEGA2560 regulator limitations is discussed in my build thread at http://3dprintboard.com/showthread.p...ll=1#post28854. A discussion follows after that, including a link into the reprap wiki where this is also discussed.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help