I've had my FF for about three weeks now. Learned enough from this forum to print several items with success. My son and I are now attempting to print him a Cyborg Beast prosthetic hand. We started simple, trying to print a thumb, but we keep getting variations of what you see below. Some specifics:
PLA
Nozzle 230c
50% fill (have tried as little as 10%)
Number of shells 5 (started with 1)
Build plate 30c
Three point leveling with post it note before each print.
Tried with support, and without.

It's supposed to look like the blue picture. Unfortunately, they don't tell you in the instructions what settings to use, some I'm flying blind.
Any help would be appreciated.


DSC_0735.jpgDSC_0734.jpgThumb_Finger_w_Bumps_preview_tinycard.jpg