Quote Originally Posted by AbuMaia View Post
; generated by Slic3r 1.1.7 on 2014-10-29 at 19:18:24

; perimeters extrusion width = 0.40mm
So the extrusion specified by Slic3r is tracking very nicely with the measured value after you set your extrusion multiplier. That's very encouraging for seeing the cal have the desired effect with Slic3r. Thanks for checking that ABU. Great info. Although I'm not sure if the calibration is affecting the Slic3r information (used as part of the calibration. I hope so since that would be dynamic and should track to other wall thickness requests), or if the slice3r information now matches the actual extrusion thickness because of the calibration (and would pertain to only that thickness that you calibrated). But either way it is good to see the calibration seems to make a difference in requested vs. actual in at least the calibrated wall thickness.