Results 1 to 3 of 3
Thread: Heat bed relay
-
10-05-2014, 03:37 PM #1
- Join Date
- May 2014
- Posts
- 11
Heat bed relay
Hi guys, I have an 8" prusa i3v and I'm trying to install a heat bed relay. Does anyone know which wires from my antec power supply to plug into the relay? There were no instructions on this that I could find on the makerfarm website.
-
10-05-2014, 05:14 PM #2
I haven't installed one, but it is in i3v RAMPS Install http://www.youtube.com/watch?v=ieBwDM1qxAA 12V
-
10-05-2014, 05:40 PM #3
The +12v outputs from the power supply are usually yellow (+12) and black (return) wires. So, if you have another connector with yellow and black wires, run those to the heat bed relay.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help