Results 1 to 10 of 14
Threaded View
-
10-01-2014, 07:21 AM #14
I'm not totally sure, but I think it might make sense that all heatbeds with glass on top will measure in similar way.
I think the thermistor being sandwiched between kapton tape, the bed, and some sort of insulating material creates a very small air gap that holds its heat in much better than the surface of the bed which is open to the environment. I wouldn't be surprised if the thermistor is measuring the correct temp for its location underneath even though this isn't a very exact measurement for the surface of the glass.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion