Auto Bed Leveling troubles

[dollarz81]

Only now my bed wont reach the set temp

[Roxy]

Only now my bed wont reach the set temp

Are you using PronterFace? Does it heat up at all? Do you have the right thermistors specified in the Configuration.h file?

And you will need to print a few 'first layers' to get the Z-Height correct. Once it is close, you still need to move it a little at a time until it is perfect. And unfortunately, you almost have to learn for yourself what that is by watching it. With that said, once you get it dialed in... Almost always, the first layer of a print will go down perfect.