Results 1 to 2 of 2
Hybrid View
-
11-15-2022, 10:16 AM #1
board changeovers are pretty simple.
Just down to how difficult the firmware is to setup.
My general thoughts are that you never need to upgrade a working printer :-)
A few basic modifications generally fix any issues and they will all print much faster than most people ever use.
Maybe a higher temp hotend - but can't think of any reason to change anything else.
But then I much prefer using printers to upgrading them :-)
One thing, klipper only works with a raspberry pi and (possibly) octoprint.
I know last time I looked into it I thought it was bloody stupid that you couldn't run it directly from the printer.Last edited by curious aardvark; 11-15-2022 at 10:23 AM.
Please explain to me how to...
Yesterday, 03:08 PM in 3D Printer Parts, Filament & Materials